Hey, I’m Jevon with Pickard USA. Are you building a custom Road Glide with a 26 or 30 inch wheel? If so, you’ll need this raked road glide fairing bracket. This bracket corrects your fairing angle after you’ve raked your neck for a 26 or 30 inch wheel. It fits 2013 and down Harley Road Glides. Our bracket is made of heavy gauge steel and is boxed in to cover up the wire harness where it mounts to the frame. Now I’m going to show you how easy it is to install our raked fairing bracket. Start by sliding all the wires thru the center of the bracket. Slide the bracket over the neck just like and mount it to the frame just like your stock one reusing your stock hardware. You’ll notice there’s some play in the bracket so you can set your desired fairing angle. Leave these bolts loose so you can adjust it the angle later. Now you’re ready to mount the inner fairing to the bracket using these four studs. Set your desired fairing angle then tighten the bracket to the frame and you’re done. If you have any questions give us a call and don’t forget to ask about our hidden road glide fairing support to compliment this bracket.
